Assembly Instructions for all Killerspin MyT tables
Step 1: Open The Box
Lay the box flat on its largest side and use a box opener or some other
sharp object to cut all the taped seams. Lift off the top layer of cardboard
and protective packaging and discard. Have friend help you lift each table
side out of the box and you're ready to attach the legs.
Step 2: Attach The Legs
The T-shaped legs come with the casters already installed. All you have to
do is attache them to the table. Simply lift and extend the base frame from
the table and slide the legs into each slot on the frame, making sure to
align the red arrows. To help with orientation, the legs will point at the
players, not the side of the table.
Using the included wrench, insert and tighten the bolts to secure. After
installation, with the legs extended and locked in place, have someone help
you rotate the table so it is top-up and resting on its new legs. Repeat for
other half of table, placing both halves together to prepare for net
installation. If necessary, use the built-in levelers on each of the four
outer legs to level the table.
Step 3: Setup & Install The Net
Unfold the net and simply insert the metal pin into the net and slide the
pin/net into the post to secure. Then, depending on your net type, you will
either clip it or hand screw it on to the seam between the two table halves.
Use the string/beads to tension the net once fully installed. The net should
be taught and without sag in the middle.